MIDI Y-Cable

$34.99

Made in the USA by Best-Tronics Pro Audio, these cables feature our exclusive metal right-angle plugs with rotating connector sleeves.

Designed to fit your MIDI gear, these are the highest quality cables available.

Quantity:
Add To Cart

Overview

MIDI_Y.jpg

Made in the USA by Best-Tronics Pro Audio, these cables feature our exclusive metal right-angle plugs with rotating connector sleeves.

The cables ship from Disaster Area with both ends set in the “12 o’clock” orientation but are easy to re-configure for your application.  Simply loosen the screw on the head shell and carefully rotate the connector sleeve and pins to your desired orientation, then tighten the screw.

The PRO MIDI cables are perfect for flat boards such as Creation, Trailer Trash, or LA Sound Design, and also work great on boards with cable access slots such as Pedaltrains.

Need to fit the plugs through the larger slots on Temple Audio boards? Carefully disassemble the head shell and pass the pin sleeve through the hole, then reassemble on the other side.

Features

  • Allows MIDI input and output from supported Disaster Area MIDI Controllers

  • Slim plug design, fits into recessed MIDI ports

  • Four 24 AWG (42×40) Soft Bare Copper Conductors

  • 95% Tinned Copper Braided Shield

  • 0.245″ Outer Diameter PVC Jacket

  • DN-5501 Right Angle Plugs rotate to 8 different positions

  • Hand Soldered in USA

  • Limited Lifetime Warranty

IMG_0856.JPG

What does this cable do?

The Disaster Area MIDI Y Cable allows you to send MIDI data in to your DMC Gen3 controller, while at the same time allowing the controller to send data out.  You only need this cable if you plan to control your Gen3 from another MIDI controller or a laptop with a MIDI interface.

Why on Earth would I want to connect a controller to my controller?

Great question!  Maybe your band uses Pro Tools or Ableton for show control, in which case you could have your laptop change patches on your pedalboard using a Gen3 controller.  Maybe you want to send MIDI clock from a master rather than generating it on the Gen3.  Or maybe you want to use your older Gen2 controller as a dedicated looper control?  Just connect its output to the plug labeled INPUT, and the other plug to the first device in your MIDI chain.  The Gen3 will merge the data coming in provide a seamless experience.

Can I use this to connect two devices to my Gen3?

No.  Daisy-chain your devices from the Gen3 MIDI output in the following manner:  DMC Gen3 output -> Device 1 MIDI input, then Device 1 MIDI output -> Device 2 MIDI input.  Repeat as needed for all of your remaining devices.

Does this cable work for my “Brand X” device?

The center connector on this cable plugs in to a Gen3 Disaster Area product ONLY, but the other two ends can plug into just about anything.  Using this cable will convert the single MIDI port on your DMC or DPC Gen3 into MIDI IN and MIDI OUT ports.  These IN and OUT ports may be connected to any standard MIDI device, so you can send messages into / thru the DMC Gen3 from another controller and out to another device.

Need a longer cable or custom configuration?  Contact our cable partner Best-Tronics Pro Audio at btpa.com

Documentation

MJ-STT Strymon Tap Tempo Cable
$15.00
TRS Insert Cable
$27.99
5P-QQ MIDI to 1/4" Cable
$15.99
5P-CBA MIDI to Chase Bliss Cable
$15.99
MJ-CBA MultiJack to Chase Bliss Cable
from $15.99